Hydrascape Miniscapes
APPLY YOUR STICKER TO A WATER BOTTLE
-
Clean your bottle with soap - water and dry completely.
-
Peel 2-3 inches off backing from the "peel this end first" end of your sticker.
-
Overlap the sticker on itself as you wrap it around the bottle, lining up the bottom edge with the previous later.
-
Smooth and apply pressure as you go, making sure to smooth out bumps or wrinkles.
‚Äã
If your sticker doesn't line up perfectly, no worries! Carefully peel it up and try again. The vinyl is forgiving.
‚Äã
Recommended: Add heat via blow dryer or heat gun to your sticker and applying pressure to add extra strength to your stick.
APPLY YOUR STICKER TO OTHER SURFACES
‚Äã
-
Clean and dry your surface.
-
Stick design background first.
-
Trim the right side and overlap, making layers in your landscape. Try placing the second layer slightly lower the first to create depth.
-
Repeat until you are satisfied with your layers.
CARS, SKIS, RACKS, BOATS, COOLERS
-
Clean and dry your surface in a climate above 50°
-
Determine the perfect spot to stick. Make a paper template first if you need to do some trimming around car logos and windows.
-
Peel, place and firmly press/apply pressure over the entire area.
-
Recommended: Add heat via blow dryer or heat gun to your sticker and applying pressure to add extra strength to your stick.
For cars, skis, boards, boats and racks: after applying heat, let your sticker cure for at least 24 hours before taking it on your next adventure if there is a chance of drastic temperature change.
‚Äã
